NStor Technologies Disk Array Enclosure Manuel d'utilisateur télécharger pdf (Page 43)

Installation

Fast Wide SCSI Mode

3 Turn on the power to the CR8e. After the power-on self-test has completed,

Status and Channel Mode LEDs will be solid green.

4 Access the Options menu on the Operator Control Panel and choose the

SAFTE CHAIN ID selection. Choose the “None” selection, refer to “SAFTE

CHAIN ID” on page 50.

5 After setting the cabinet identiﬁcations you must power cycle the subsystem.

Observe normal power cycling precautions by waiting a minimum of ﬁve (5)

seconds before adding power again.

This will reset the SCSI IDs to a default setting that prevents a SCSI ID

conﬂict under normal conditions.

6 Power up your computer system and run the conﬁguration program.

This completes the hardware installation.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 91 92

Pas de commentaire

NStor Technologies Disk Array Enclosure Manuel d'utilisateur Page 43