NStor Technologies Disk Array Enclosure Manuel d'utilisateur Page 46

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 45
Installation
Fast Wide SCSI Mode
34
A Dual-Bus Enclosure with Two Single-Bus Enclosures
With this configuration you will be able to expand the capacity of each SCSI
channel of a Dual-Bus enclosure by adding a Single-Bus enclosure to each
channel. This provides up to twelve drives per SCSI channel for a total capacity of
218 GB (using 18 GB disk drives) on each channel.
CAUTION: Ensure that the power switch is in the OFF (O) position for both the
host system and the CR8e subsystem before connecting any cables.
1 Connect one end of a one meter data cable to the Channel #1 connector on
the AM RAID Controller.
2 Connect the other end of the first data cable to the Channel #0 SCSI connector
on the right side or upper I/O Interface card.
3 Connect one end of the second data cable to the Channel #2 connector on the
AM RAID Controller.
4 Connect the other end of the second data cable to the Channel #1 SCSI
connector on the right side or upper I/O Interface card.
5 Locate the jumper cables. Connect one end of one jumper cable to the
Channel #0 SCSI connector on the left side or lower I/O Interface card
installed in the Dual-Bus enclosure (master).
Rear View CR8e
with Single-Bus Module installed.
TOP
I/O Interface
Card
I/O Interface
Card
I/O Interface
Card
I/O Interface
Card
I/O Interface
Card
I/O Interface
Card
1 meter data cable
1 meter data cable
14-inch jumper cable
14-inch jumper cable
Ultra SCSI
RAID Controller
Ch 0
Ch 1
Ch 0
Ch 1
Ch 1
Ch 2
Rear View CR8e
with Dual-Bus Module installed.
TOP
Ch 0
Ch 1
Ch 0
Ch 1
Rear View CR8e
with Single-Bus Module installed.
TOP
Ch 0
Ch 1
Ch 0
Ch 1
Vue de la page 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 91 92

Commentaires sur ces manuels

Pas de commentaire